Toyota Tundra 2005 Service - Repair - Maintenance page 2236

CL−12
CLUTCH − CLUTCH RELEASE CYLINDER
DISASSEMBLY
1. REMOVE BOOT AND PUSH ROD
(a) Pull out the boot with the push rod.
(b) Remove the boot from the push rod.
2. REMOVE PISTON AND SPRING
Using compressed air, remove the piston with the spring from
the cylinder.
NOTICE:
S
Blowing off the air may cause the piston to jump out.
When removing the piston, hold it by hand using a
waste.
S
Take care not to splash brake fluid when air−blowing.
3. REMOVE BLEEDER PLUG
Q02475
CL02F−11