Toyota Tundra 2005 Service - Repair - Maintenance page 2250

A
A
B
B
1.6 kW Type:
2.0 kW Type:
MANUAL TRANSMISSION (RA60)
INSTALLATION
1.
Install the transmission cover with the 5 bolts.
2.
Install the engine rear mounting with the 4 bolts.
D13784
3.
A
(a)
A
(b)
A
B
B
D13782
4.
(a)
(b)
D13781
5.
(a)
(b)
(c)
D14120
− MANUAL TRANSMISSION UNIT
INSTALL TRANSMISSION COVER
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
INSTALL ENGINE REAR MOUNTING
Torque: 65 N·m (660 kgf·cm, 48 ft·lbf)
INSTALL TRANSMISSION
Install the wire harness to the clamps of the transmission.
Install the transmission to the engine with the 9 bolts.
Torque:
Bolt A: 72 N·m (730 kgf·cm, 53 ft·lbf)
Bolt B: 37 N·m (380 kgf·cm, 27 ft·lbf)
INSTALL CROSSMEMBER
Install the crossmember with the 4 bolts, washers and
nuts.
Torque: 72 N·m (734 kgf·cm, 53 ft·lbf)
Install the 4 set bolts for the engine rear mounting.
Torque: 18 N·m (180 kgf·cm, 13 ft·lbf)
INSTALL STARTER
Install the starter with the 2 bolts.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
Connect the terminal and install the nut.
Torque: 9.8 N·m (100 kgf·cm, 7 ft·lbf)
Connect the connector.
MT−7
MT0HQ−01