Toyota Tundra 2005 Service - Repair - Maintenance page 2215

Turn
CHARGING (2UZ−FE) −
REMOVAL
1. REMOVE ENGINE UNDER COVER
2. REMOVE THROTTLE BODY COVER
3. DISCONNECT CABLE FROM NEGATIVE (−) BATTERY
TERMINAL
4. DISCONNECT INTAKE AIR CONNECTOR FROM
THROTTLE BODY
5. REMOVE GENERATOR DRIVE BELT
Loosen the belt tension by turning the belt tensioner counter-
clockwise, and remove the drive belt.
HINT:
The pulley bolt for the belt tensioner has a left−hand thread.
6. REMOVE PS VANE PUMP FROM ENGINE
(See page SR−61)
7. REMOVE GENERATOR
(a) Disconnect the generator connector.
B00809
(b) Remove the terminal cap and nut, and disconnect the
generator wire.
(c) Disconnect the wire clamp from the cord clip on the gener-
ator.
(d) Remove the bolt, 2 nuts and generator.
GENERATOR (Towing Package Spec.)
CH−19
CH0LS−02