Pulley
SST
SST (B)
CHARGING (2UZ−FE)
REASSEMBLY
1.
(a)
(b)
B16368
2.
(a)
B16521
(b)
B16512
(c)
B16364
3.
(a)
(b)
Turn SST (A)
(c)
B16520
−
GENERATOR (Towing Package Spec.)
INSTALL ROTOR TO DRIVE END FRAME
Place the drive end frame on the pulley.
Install the rotor to the drive end frame.
INSTALL COIL ASSEMBLY
Place the generator washer on the rotor.
Using SST and a press, slowly press in the coil assembly.
SST
09285−76010
Install the coil assembly with the 4 bolts.
Torque: 5.8 N·m (59 kgf·cm, 51 in.·lbf)
INSTALL PULLEY
Install the pulley to the rotor shaft by tightening the pulley
nut by hand.
Hold SST (A) with a torque wrench, and tighten SST (B)
clockwise to the specified torque.
SST
09820−63011
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
Check that SST (A) is secured to the pulley shaft.
CH−25
CH0LW−01