Show Cam-Ipv6 Extended-Prefix - Dell C9000 Series Reference Manual

Disabling unicast routing on an E-Series chassis causes the following behavior:

show cam-ipv6 extended-prefix

Display the currently configured and next-boot settings for extended IPv6 prefixes (/65 to /128) in LPM CAM.
C9000 Series
Syntax
show cam-ipv6 extended-prefix
Defaults None
Command Modes
EXEC
EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.5(0.1)
9.3(0.1)
Usage Information You can use this command to view the maximum number of extended IPv6 prefix
entries supported in LPM CAM. The output displays the current value and the new value
applicable after a switch reload.
Example
Dell#show cam-ipv6 extended-prefix
Cam-Ipv6-LPM Extended Prefix
--------------------------------
Current Settings
• static and protocol learned routes are removed from RTM and from the CAM;
packet forwarding to these routes is terminated
• connected routes and resolved neighbors remain in the CAM and new IPv6
neighbors are still discoverable
• additional protocol adjacencies (OSPFv3 and BGP4) are brought down and no
new adjacencies are formed
• the IPv6 address family configuration (under router bgp) is deleted
• IPv6 Multicast traffic continues to flow unhindered
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S6000.
IPv6 Basics 1285