Table of Contents
Advertisement
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(route-map)#match ip address prefix-list test
match ipv6 address prefix-list
Use this command to configure a route map to match based on an IPv6
destination prefix. To delete a match statement from a route map, use the no
form of this command.
Syntax
match ip address prefix-list prefix-list-name [prefix-list-name...]
no match ip address prefix-list [ prefix-list-name [prefix-list-name...] ]
•
prefix-list prefix-list-name—The name of an IPv6 prefix list used to
identify the set of matching routes. Up to eight prefix lists may be
specified.
Default Configuration
No match criteria are configured by default.
Command Mode
Route Map Configuration
User Guidelines
If multiple prefix lists are specified in one statement, a match occurs if a
prefix matches any one of the prefix lists. If a match ipv6 address statement is
configured within a route map section that already has a match ipv6 address
statement, the new prefix lists are added to the existing set of prefix lists, and
a match occurs if any prefix list in the combined set matches the prefix.
The command no match ip address prefix-list removes the match term and
all its prefix lists.
Layer 3 Routing Commands
1398
Advertisement
Table of Contents
