Show Ip Route Summary; Show Tcp Statistics - Dell PowerEdge M I/O Aggregator Reference Manual

show ip route summary

View a table summarizing the IP routes in the switch.
show ip route summary
Syntax
Command Modes
EXEC
EXEC Privilege
Command
Version 8.3.17.0
History
Example Figure 12-12. show ip route summary Command Example
FTOS>show ip route summary
Route Source
connected
static
ospf 100
Total
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
FTOS>
Table 12-8. show ip route summary Column Headings
Column Heading
Route Source
Active Routes
Non-active Routes
ospf 100
Total 1388 active...
Related
show ip route
Commands

show tcp statistics

View information on TCP traffic through the switch.
Syntax show tcp statistics
Command Modes
EXEC Privilege
Command
Version 8.3.17.0
History
Supported on M I/O Aggregator
Active Routes
17
3
1368
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
1388
Description
Identifies how the route is configured in FTOS.
Identifies the best route if a route is learned from two protocol sources.
Identifies the back-up routes when a route is learned by two different protocols. If the
best route or active route goes down, the non-active route will become the best route.
If routing protocols (OSPF, RIP) are configured and routes are advertised, then
information on those routes is displayed.
Displays the number of active and non-active routes and the memory usage of those
routes.
If there are no routes configured in the FTOS, this line does not appear.
Displays information about the routes found in switch.
Supported on M I/O Aggregator
Non-active Routes
0
0
2
2
IPv4 Routing | 173