Show Tcp Statistics - Dell S6000 Reference Manual

ICMP statistics:
unreachable
quench
UDP statistics:
socket full
TCP statistics:
ARP statistics:
Routing Processor1 IP Traffic:

show tcp statistics

View information on TCP traffic through the switch.
S6000
Syntax
show tcp statistics {all | cp | rp1 | rp2}
Parameters
all
cp
rp1
rp2
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
770
0 unknown protocol, 0 not a gateway
0 security failures, 0 bad options
Frags: 0 reassembled, 0 timeouts, 0 too big
0 fragmented, 0 couldn't fragment
Bcast: 28 received, 0 sent; Mcast: 0 received, 0 sent
Sent: 16048 generated, 0 forwarded
21 encapsulation failed, 0 no route
Rcvd: 0 format errors, 0 checksum errors, 0 redirects, 0
0 echo, 0 echo reply, 0 mask requests, 0 mask replies, 0
0 parameter, 0 timestamp, 0 info request, 0 other
Sent: 0 redirects, 0 unreachable, 0 echo, 0 echo reply
0 mask requests, 0 mask replies, 0 quench, 0 timestamp
0 info reply, 0 time exceeded, 0 parameter problem
Rcvd: 0 total, 0 checksum errors, 0 no port
0 short packets, 0 bad length, 0 no port broadcasts, 0
Sent: 0 total, 0 forwarded broadcasts
Rcvd: 23829 total, 0 checksum errors, 0 no port
Sent: 16048 total
Rcvd: 156 requests, 11 replies
Sent: 21 requests, 10 replies (0 proxy)
Enter the keyword all to view all TCP information.
Enter the keyword cp to view only TCP information from the
Control Processor.
Enter the keyword rp1 to view only TCP statistics from
Route Processor 1.
Enter the keyword rp2 to view only TCP statistics from
Route Processor 2.
IPv4 Routing