Shutdown - Dell Catalyst 3130 Command Reference Manual

2 V ]
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands

shutdown

Use the shutdown interface configuration command on the switch stack or on a standalone switch to
disable an interface. Use the no form of this command to restart a disabled interface.
Syntax Description
This command has no arguments or keywords.
Defaults The port is enabled (not shut down).
Command Modes Interface configuration
Command History Release
12.2(40)EX1
Usage Guidelines The shutdown command causes a port to stop forwarding. You can enable the port with the no
shutdown command.
The no shutdown command has no effect if the port is a static-access port assigned to a VLAN that has
been deleted, suspended, or shut down. The port must first be a member of an active VLAN before it can
be re-enabled.
The shutdown command disables all functions on the specified interface.
This command also marks the interface as unavailable. To see if an interface is disabled, use the show
interfaces privileged EXEC command. An interface that has been shut down is shown as
administratively down in the display.
Examples
These examples show how to disable and re-enable a port:
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# shutdown
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# no shutdown
You can verify your settings by entering the show interfaces privileged EXEC command.
Related Commands Command
show interfaces
OL-12248-03
shutdown
no shutdown
Modification
This command was introduced.
Description
Displays the statistical information specific to all interfaces or to a specific
interface.
Cisco Catalyst Blade Switch 3120 for HP Command Reference
shutdown
2-689