Bulk Configuration; Interface Range; Bulk Configuration Examples - Dell S6100 Configuration Manual

Hide thumbs Also See for S6100:

Table of Contents

xor4 —Upper 8 bits of CRC16-BISYNC and lower 8 bits of xor4

xor8 — Upper 8 bits of CRC16-BISYNC and lower 8 bits of xor8

xor16 — uses 16 bit XOR.

Bulk Configuration

Bulk configuration allows you to determine if interfaces are present for physical interfaces or configured for logical interfaces.

An interface range is a set of interfaces to which other commands may be applied and may be created if there is at least one valid interface

within the range.

Bulk configuration excludes from configuration any non-existing interfaces from an interface range. A default VLAN may be configured only

if the interface range being configured consists of only VLAN ports.

The interface range command allows you to create an interface range allowing other commands to be applied to that range of

The interface range prompt offers the interface (with slot and port information) for valid interfaces. The maximum size of an interface

range prompt is 32. If the prompt size exceeds this maximum, it displays (...) at the end of the output.

Non-existing interfaces are excluded from the interface range prompt.

When creating an interface range, interfaces appear in the order they were entered and are not sorted.

The show range command is available under Interface Range mode. This command allows you to display all interfaces that have been

validated under the interface range context.

The show configuration command is also available under Interface Range mode. This command allows you to display the running

configuration only for interfaces that are part of interface range.

You can avoid specifying spaces between the range of interfaces, separated by commas, that you configure by using the interface

range command. For example, if you enter a list of interface ranges, such as interface range fo 1/1/1-6,te 1/11/1, this

configuration is considered valid. The comma-separated list is not required to be separated by spaces in between the ranges. You can

associate multicast MAC or hardware addresses to an interface range and VLANs by using the mac-address-table static

multicast-mac-address vlan vlan-id output-range interface command.

Use the interface range command for bulk configuration.

Create a Single-Range

Create a Multiple-Range

Exclude Duplicate Entries

Exclude a Smaller Port Range

Overlap Port Ranges