Interface Null - Dell C9000 Series Reference Manual

If your system has two RPMs installed, use the show redundancy command to display
which RPM is the Primary RPM.
Example
Dell(conf)# interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
Related
management route
Commands
or a forwarding router.
duplex (Management)
specified line card.
speed (Management interface)

interface null

Configure a Null interface on the switch.
C9000 Series
Syntax
interface null number
Parameters
number
Defaults Not configured; number = 0
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
— configures a static route that points to the Management interface
— clears the forwarding information base (FIB) entries on a
— clears the FIB entries on a specified line card.
Enter zero (0) as the Null interface number.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Interfaces 936