Interface Null - Dell Z9500 Command Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.11.1
8.1.1.0
7.5.1.0
6.4.1.0
Usage
You cannot delete a Management port.
Information
The Management port is enabled by default (no shutdown). To assign an IP
address to the Management port, use the ip address command.
If your system has two RPMs installed, use the show redundancy command to
display which RPM is the Primary RPM.
Example
Dell(conf)#interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
Related
management route
Commands
interface or a forwarding router.
duplex (Management)
specified line card.
speed (Management interface)

interface null

Configure a Null interface on the switch.
Z9500
Syntax
interface null number
Parameters
number
Defaults Not configured; number = 0
Interfaces
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S55, S60, and S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced
— configures a static route that points to the Management
— clears the forwarding information base (FIB) entries on a
— clears the FIB entries on a specified line card.
Enter zero (0) as the Null interface number.
845