Dcb <Ets | Pfc> Enable - Dell Z9500 Command Reference Manual

Example
Dell(conf)#dcb pfc-queues 4
dcb <ets | pfc> enable
Enable priority flow control or enhanced transmission selection on interface.
Syntax
dcb <ets | pfc> enablepfc >enable
•
•
Defaults Enable
Command INTERFACE
Modes
Command
Version
History
9.7(0.0)
Usage
PFC and ETS are enabled by default on the interfaces when DCB is globally enabled
Information
(refer to dcb enable). In some network topology, you may want to disable PFC on
an interface and apply link level flow control; Similarly you may want to disable ETS
on an interface and apply QoS bandwidth configurations.
Limitations
•
•
Related dcb-map
Commands
Data Center Bridging (DCB)
To disable ETS on interface, use "no dcb ets enable" command.
To disable PFC on interface, use "no dcb pfc enable" command.
Description
Introduced on the Z9500.
"dcb-map" CLI on interface is mutually exclusive to "no dcb ets enable" and
"no dcb pfc enable".
"pfc priority" CLI is mutually exclusive to "no dcb pfc enable"
command.
— applies dcb-map profile on interface.
645