Dcb <Ets | Pfc> Enable - Dell S4810 Reference Manual

amount of buffer space to be allocated for each priority and the pause or resume
thresholds for the buffer. This method of configuration enables you to effectively
manage and administer the behavior of lossless queues.
Example
Dell(conf)#dcb pfc-queues 4
dcb <ets | pfc> enable
Enable priority flow control or enhanced transmission selection on interface.
This feature is supported on S4810 platform.
Syntax
dcb <ets | pfc> enablepfc >enable
•
•
Defaults Enable
Command INTERFACE
Modes
Command
Version 9.3
History
(0.1)
Usage
PFC and ETS are enabled by default on the interfaces when DCB is globally enabled
Information
(refer to dcb enable). In some network topology, you may want to disable PFC on
an interface and apply link level flow control; Similarly you may want to disable ETS
on an interface and apply QoS bandwidth configurations.
Limitations
•
•
•
•
Related dcb-input—applies dcb-input profile on interface.
Commands
dcb-policy
pfc
dcb-map—applies dcb-map profile on interface.
590
To disable ETS on interface, use "no dcb ets enable" command.
To disable PFC on interface, use "no dcb pfc enable" command.
Introduced on S6000, S4810, and S4820T.
"dcb-map" CLI on interface is mutually exclusive to "no dcb ets enable" and
"no dcb pfc enable".
"pfc priority" CLI is mutually exclusive to "no dcb pfc enable"
command.
Deprecated CLI "dcb-policy input" and "no dcb pfc enable" cannot
coexist at interface level.
Deprecated CLI "dcb-policy output" and "no dcb ets enable" cannot
coexist at interface level.
output—applies dcb-output profile on interface.
priority—enable PFC on 802.1p priority traffic without using a dcb-map.
Data Center Bridging (DCB)