Fcoe Priority-Bits; Iscsi Priority-Bits - Dell Z9500 Reference Manual

fcoe priority-bits

Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits
command.
Parameters
priority-bitmap
Defaults 0x8
Command PROTOCOL LLDP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
Usage This command is available at the global level only.
Information

iscsi priority-bits

Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.
Syntax
iscsi priority-bits priority-bitmap
To remove the configured iSCSI priority, use the no iscsi priority-bits
command.
Parameters
priority-bitmap
Defaults 0x10
Command PROTOCOL LLDP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
592
Enter the priority-bitmap range. The range is from 1 to FF.
Description
Introduced on the Z9500.
Enter the priority-bitmap range. The range is from 1 to FF.
Description
Introduced on the Z9500.
Data Center Bridging (DCB)