Set Next-Hop - Dell Force10 Z9000 Reference Manual

To delete a setting, use the no set metric-type command.
Parameters
internal
external
type-1
type-2
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
set automatic-tag
Commands
set level
set metric
set tag

set next-hop

Configure a filter to specify an IP address as the next hop.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax set next-hop ip-address
To delete the setting, use the no set next-hop ip-address command.
Parameters
ip-address
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1
Version 8.3.7.0
Enter the keyword internal to assign the Interior Gateway
Protocol metric of the next hop as the route's BGP MULTI_EXIT_DES
(MED) value.
Enter the keyword external to assign the IS-IS external metric.
Enter the keyword type-1 to assign the OSPF Type 1 metric.
Enter the keyword type-2 to assign the OSPF Type 2 metric.
Introduced on the Z9000.
Introduced on the S4810.
Implemented the keyword internal.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– computes the tag value of the route.
– specifies the OSPF area for route redistribution.
– specifies the metric value assigned to redistributed routes.
– specifies the tag assigned to redistributed routes.
Specify an IP address in dotted decimal format.
Introduced on the Z9000.
Introduced on the S4810.
299