Set Next-Hop - Dell C9000 Series Reference Manual

Version
6.1.1.0
Related
set automatic-tag
Commands
set level
set metric
set tag

set next-hop

To specify an IP address as the next hop, configure a filter.
C9000 Series
Syntax
set next-hop ip-address
To delete the setting, use the no set next-hop ip-address command.
Parameters
ip-address
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
Description
Introduced on the E-Series.
— computes the tag value of the route.
— specifies the OSPF area for route redistribution.
— specifies the metric value assigned to redistributed routes.
— specifies the tag assigned to redistributed routes.
Specify an IP address in dotted decimal format.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Access Control Lists (ACL) 384