Next Steps - Dell Networking N20 Series Installation Manual

NOTE: In the User-Configured Cascade Ports field, A (active) indicates that a C9010 port is up (no shutdown) and configured
as a cascade port; I (inactive) indicates that a port is down and configured as a cascade port.
Dell# show interface port-channel brief
Codes: L - LACP Port-channel
O - OpenFlow Controller Port-channel
A - Auto Port-channel
LAG Mode Status
A 258 N/A up

Next Steps

After you complete the initial provisioning, you can configure L2 software features on the N20xx system from the C9010 console CLI,
including LLDP, 802.1x, LACP, loop detection and BPDU Guard. No other L2 protocols are supported. IP address and L3 protocol
configuration on N20xx ports are not supported. For detailed information, see the Dell Networking Configuration Guide for C9000 Series
Switches.
When the N20xx system is online, you can enter the connect pe pe-id command on the C9010 console to remotely log in to the
N20xx CLI. To log in, enter the user name peadmin and the password calvin. After logging in, you can enter show and stack
renumbering commands on the N20xx system.
Uptime Ports
14:45:26 Te 0/1,2 (up)
Starting and Configuring the N20xx Switch 21