Set Next-Hop - Dell S6000 Reference Manual

external
type-1
type-2
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
set automatic-tag
Commands
set level
set metric
set tag

set next-hop

To specify an IP address as the next hop, configure a filter.
S6000
Syntax
set next-hop ip-address
To delete the setting, use the no set next-hop ip-address command.
254
Enter the keyword external to assign the IS-IS external
metric.
Enter the keyword type-1 to assign the OSPF Type 1 metric.
Enter the keyword type-2 to assign the OSPF Type 2 metric.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Implemented the keyword internal.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— computes the tag value of the route.
— specifies the OSPF area for route redistribution.
— specifies the metric value assigned to redistributed routes.
— specifies the tag assigned to redistributed routes.
Access Control Lists (ACL)