Set Next-Hop - Dell Z9500 Reference Manual

Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related
set automatic-tag
Commands
set level
set metric
set tag

set next-hop

To specify an IP address as the next hop, configure a filter.
Z9500
Syntax
set next-hop ip-address
To delete the setting, use the no set next-hop ip-address command.
Parameters
ip-address
Defaults Not configured.
Command ROUTE-MAP
Modes
Access Control Lists (ACL)
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Implemented the keyword internal.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— computes the tag value of the route.
— specifies the OSPF area for route redistribution.
— specifies the metric value assigned to redistributed routes.
— specifies the tag assigned to redistributed routes.
Specify an IP address in dotted decimal format.
313