Canon imageRUNNER ADVANCE 6075 Series Service Manual page 79

2
Technology > Main Controller > Controls > HDD mirroring feature (option)
● To start using this feature (installation)
Install HDD2
Install the mirroring PCB and LED PCB
for HDD1,HDD2
Turn ON the main power
Turn ON the mirroring feature
Turn OFF the main power
Turn ON the main power
Start "Rebuild"
Complete "Rebuild"
2 Technology > Main Controller > Controls > HDD mirroring feature (option)
HDD1 is connected to Ch A on the
mirroring PCB
HDD2 is connected to Ch B on the
mirroring PCB.
Slot.1 (HDD1)
Slot.2 (HDD2)
CH B
CH A
(Lv.1) COPIER > OPTION > FNC-SW
> W/RAID ---> "1"
st
The storage data of the 1 HDD is
nd
automatically copied to the 2 HDD (this
operation is called "Rebuild".
Time needed:
80 GB HDD --- Approx. 20 minutes
250GB HDD ---Approx. 60 minutes
F-2-34
"Rebuild" progress is shown in a massage at the status line on the control panel.
"Copying hard disk data... xx%"
NOTE:
• This machine can be used even during "rebuild" process (operation is performed
with HDD1)
• The HDD will not be damaged even if turning OFF the power during "rebuild"
process. "Rebuild" is resumed once the power is turned ON the next time. This
does not apply in the case of blackout or disconnecting the power code during
"rebuild" process
2-25
2-25