NEC Univerge sv8500 Manual page 1732

When you have finished, the following message appears on the Maintenance Console.
*****************************************
* MG(SIP) ONLINE START
*****************************************
Note: Both LAN1 and LAN2 must be connected to make MG-SIP128 [MG-128SIPMGJ] online. (For a
one-port configuration, only LAN1 connection makes MG-SIP128 [MG-128SIPMGJ] online.)
Step6: Checking the lamp status of LINK and SPEED at Ether1 and Ether2 of MG-SIP128 [MG-
128SIPMGJ]
If the connection is established, the following LINK lamps of MG-SIP128 [MG-128SIPMGJ] will light
green in a few minutes.
Note: For a one-port configuration, LINK lamp at Ether 2 connector does not light.
• Ether1 connector on LAN side: LINK lamp
• Ether2 connector on WAN side: LINK lamp
[SPEED lamp is lighting in orange]
• The MG-SIP128 [MG-128SIPMGJ] connects to a network with transmitting speed of 1Gbps.
[SPEED lamp is lighting in green]
• The MG-SIP128 [MG-128SIPMGJ] connects to a network with transmitting speed of 100Mbps.
If you expected transmitting speed of 1Gbps, check a connected network device and a cable be-
tween them.
[SPEED lamp is not lighting]
• The MG-SIP128 [MG-128SIPMGJ] connects to a network with transmitting speed of 10Mbps.
If you expected transmitting speed of 1Gbps or 100Mbps, check a connected network device and a
cable between them.
Step7: Checking the lighting of ONLINE lamp.
If the settings are correct, ONLINE lamp of MG-SIP128 [MG-128SIPMGJ] lights in green.
18.3.6 Operation Check
Make sure the MG-SIP128 [MG-128SIPMGJ] is in normal operation by the following procedure.
Step1: When the configuration settings are completed, reboot the MG-SIP128 [MG-128SIPMGJ]
by using "reboot" command.
Step2: Make sure the following message appears on the Maintenance Console after rebooting.
*****************************************
* MG(SIP) ONLINE START
*****************************************
*
*
VOL.2-1479
MG-SIP128 [MG-128SIPMGJ]