NEC Univerge sv8500 Manual page 1672

show
(1) arp
Displaying of ARP table
This command is used to show the Address Resolution Protocol (ARP) table of MG-SIP128 [MG-
128SIPMGG].
[Setting Example]
MG(SIP)> show arp
Address Note 1 HWtype HWaddress
192.168.0.250 ether
192.168.0.99 ether
192.168.0.1 ether
Note:
Actual values such as Address or HWaddress may differ from this sample.
Note 1: Address
Note 2: HWaddress : Physical address /Hardware address (For Ethernet, MAC address of an entry)
Note 3:
Flags Mask : Entry type (C: Used for normal entries only.)
(2) config
Displaying of a configuration data list
This command is used to show the configuration that has been currently specified for the MG-SIP128
[MG-128SIPMGG].
The following shows a sample display.
[MAC configuration data]
MG(SIP)> show config
[2012-05-05 14:49:29]
[SP-4051:01.00.00.00]
0=MAC Data
1=DRS Data
2=Common Config Data
3=Port Config Data
Note 2
00:1D:92:9E:2A:E0 C
00:B0:D0:31:FE:64 C
00:30:13:76:7B:52 C
: IP address (IP address or host name of an entry)
VOL.2-1419
MG-SIP128 [MG-128SIPMGG]
Flags Mask Note 3 Iface
eth0
eth0
eth0
Time when the configuration is
acquired.
Software version information of
MG-SIP128 [MG-128SIPMGG]
MAC Data=MAC configuration
data
DRS Data=Configuration data of
the Telephony Server
Common Config Data=Common
configuration data
Port Config Data=Port configura-
tion data