NEC Univerge sv8500 Manual page 1686

SIP Access Filter
Burst Access Filter
-------------------------------------------------
set sip_transport:
SIP transport protocol
:disable
:disable
:UDP
VOL.2-1433
MG-SIP128 [MG-128SIPMGG]
When "enable" is selected for
"SIP Access Filter" by the SET
command "sip_accfilter",
"enable" and the following set-
tings are displayed:
• When IP address is assigned by
the SET command
"sip_server"
(SIP server IP Address:
192.168.100.100)
SIP Access Filter mask:
255.255.255.255
• When FQDN is assigned by the
SET command "sip_server"
(SIP server FQDN:
sipserver.nec.com)
SIP Access Filter mask:
255.255.255.255
When "disable" is selected for
"SIP Access Filter", the above set-
tings are not shown.
When "enable" is selected for
"Burst Access Filter" by the SET
command "sip_accfilter",
"enable" and the following set-
tings are displayed:
Burst Access Filter: enable
Burst Access limit timer value: 30
Burst Access limit number value:
500
Burst Access reject response code:
600
When "disable" is selected for
"Burst Access Filter", the above
settings are not shown. Note 5
When "TCP" is selected by the
SET command "sip_transport",
"TCP" is displayed.