NEC Univerge sv8500 Manual page 1690

SP-4051 MGSIP PROG-G
(5) route
Displaying of Route table
This command is used to show the Route Table of MG-SIP128 [MG-128SIPMGG].
[Setting Example]
MG(SIP)> show route
Kernel IP routing table
Destination Gateway Genmask
172.16.0.0 *
192.0.0.0 *
Note: The conditions of this command are as follows.
• Actual values such as Destination or Genmask may differ from this sample.
• It may take time to display the route table information when DNS server IP address has been assigned. ("set
dnsaddress")
• Settings of "Flags", "Metric", Ref", "Use", "MSS", "Window" and "irtt" do not affect the operation of
MG-SIP128 [MG-128SIPMGG] directly.
Note 6: Flags
Note 7: Metric
Note 8: Ref
Note 9: Use
Note 10: MSS
Note 11: Window : Indicates a window size of TCP.
Note 12: irtt
(6) status
Displaying status of ports and registration
This command is used to show status of ports and registration on MG-SIP128 [MG-128SIPMGG].
[Setting Example]
• If displaying port status
MG(SIP)> show status
|SP-4051 |Ver01.00.00.00
Note 5 Note 6 Note 7 Note 8
Flags MetricRef
255.255.0.0 U
255.0.0.0 U
: Indicates a route type. ("U" is usable, "H" is host, "G" is gateway.)
: Indicates route metric. (In the range of one to 9999.)
: Indicates the number that the route is referred.
: Indicates the number that the route was actually used (routed).
: Indicates the Maximum Segment Size (MSS: Maximum data size of a TCP segment) at
a route.
: Indicates the initial round-trip time of TCP connections to each route. MG-SIP128
[MG-128SIPMGG] regards a TCP connection where no reply lasts for the round-trip
time (1 to 12000) as no connection.
Use Iface MSS
0 0 0
0 0 0
VOL.2-1437
MG-SIP128 [MG-128SIPMGG]
Software version information of
MG-SIP128 [MG-128SIPMGG]
Note 9 Note 10 Note 11
Window irtt
eth1 0 0
eth0 0 0
0
0