NEC Univerge sv8500 Manual page 1678

0=MAC Data
1=DRS Data
2=Common Config Data
3=Port Config Data
4=SIP Config Data
5=Route Config Data
9=Exit
Select a reference number:3
Using all port
Ether[1]
IP address:172.16.253.200
Subnet :255.255.255.0
Interface :Speed/Duplex=Auto/Auto
Port type :IPX Side Port
Ether[2]
IP address:192.168.35.200
Subnet :255.255.255.0
Interface :Speed/Duplex=Auto/Auto
Port type :SIP Side Port
[SIP configuration data]
MG(SIP)> show config
[2012-05-05 14:49:29]
[SP-4051:01.00.00.00]
VOL.2-1425
MG-SIP128 [MG-128SIPMGG]
MAC Data=MAC configuration
data
DRSData=Configuration data of
the Telephony Server
Common Config Data=Common
configuration data
Port Config Data=Port configura-
tion data
SIP Config Data=SIP configura-
tion data
Route Config Data=Route infor-
mation configuration data
End of show command
Select "3".
Data that is set to each port num-
ber is displayed.
Displays the current setting of the
Ether[2] information.
When IPv6 (=1) is selected by "set
ip_version" command, this IP
address will be shown in IPv6
address format.
Time when the configuration is
acquired.
Software version information of
MG-SIP128 [MG-128SIPMGG]