Avaya Communication Manager Administrator's Manual page 1277

Outgoing Dial Type
This field sets the method used to transmit digits for an outgoing call. Usually, you should match what
your central office provides. See
field appears for Access, APLT, CO, DIOD, DMI-BOS, FX, RLT, and WATS trunk groups. It also
appears for Tie trunk groups when the Trunk Signaling Type field is blank, cont, or dis.
DIOD trunks support pulsed and continuous E&M signaling in Brazil and discontinuous E&M signaling
in Hungary.
Valid entries
tone
rotary
r1mf
mf
automatic
Administrator's Guide for Avaya Communication Manager
November 2003
Types of address transmission
Usage
Enter tone to use Dual Tone Multifrequency (DTMF) addressing,
also known as "touch tone" in the U.S. Entering tone actually
allows the trunk group to support both DTMF and rotary signals.
For pulsed and continuous E&M signaling in Brazil and for
discontinuous E&M signaling in Hungary, use tone or mf.
Enter rotary if you only want to allow the dial pulse addressing
method used by non-touch tone phones. If you have a full touch
tone system internally and a connection to a central office that only
supports rotary dialing, for example, it would be appropriate to enter
rotary.
Enter r1mf for CAMA trunk groups. It is the only outgoing dial
type allowed on CAMA trunk groups.
Enter r1mf to allow Russian MF Packet Signaling on outgoing
trunks. Russian MF Packet Signaling carries calling party number
and dialed number information.
Enter mf if the Trunk Signaling Type
Multifrequency Signaling
System-Parameters Customer-Options screen in order for you to
enter mf here.
You may not enter mf if the
for page 2) is y.
For pulsed and continuous E&M signaling in Brazil and for
discontinuous E&M signaling in Hungary, use tone or mf.
Enter automatic for tie trunks if the
blank. This provides "cut-through" operation to outgoing callers
who dial a trunk access code, connecting them directly to central
office dial tone and bypassing any toll restrictions administered on
Communication Manager.
on page 1745 for more information. This
Group type field must be set to co.
field is blank. The
field must be enabled on the
field (Field descriptions
Used for DCS
Trunk Signaling Type
Screen Reference
Trunk Group
field is
1277