Avaya Communication Manager Administrator's Manual page 788

Screen Reference
DS1 Circuit Pack
Name
Use this field to assign a significant, descriptive name to the DS1 link. Avaya recommends putting the
vendor's circuit ID for the link in this field, because that information helps you troubleshoot problems
with the link, but you could also use this field to indicate the function or the destination of this DS1
facility. In that case, put the DS1 link circuit ID in the
link.
Valid entries
1–15 characters
Peer Protocol
This allows you to administer the peer level protocol that will operate in a private network. This field
appears if the
Interface
on the System-Parameters Customer-Options screen must be y.
Valid entries
Q-SIG
TTC
Protocol Version
In countries whose public networks allow multiple layer-3 signaling protocols for ISDN-PRI service, this
field selects the protocol that matches your network service provider's protocol. See
signaling administration for ISDN-PRI Layer 3
protocols.
This field appears only when:
•
The Signaling Mode
•
The Signaling Mode
network.
Valid entries
a, b, c, d
!
The AT&T Switched Network Protocol does not support restricted displays of connected numbers.
Therefore, if you administer the 1a country-protocol/protocol-version combination on the DS1
screen, you cannot set the
Group screen, as this causes display problems.
788
Usage
Enter a name for the DS1 link.
field is peer-master or peer-slave. To enter Q-SIG, the
Usage
This implements QSIG Network Basic Call.
For private networking. Requires a Digital Trunk (Japan 2 MB
TTC) (TN2242) circuit pack.
field is isdn-pri and the
field is isdn-pri, the
Usage
The entry in this field must match the protocol used by your
network service provider, so work with your vendor to determine
the appropriate entry.
WARNING:
Send Connected Number
Administrator's Guide for Avaya Communication Manager
Name field of the trunk group associated with this
on page 789 to see which countries support which
Connect field is network.
Connect field is pbx, and the
field to r (restricted) on the ISDN-PRI Trunk
field
Basic Call Setup
Public network
Interface field is user or
November 2003