Signaling Group - Avaya Communication Manager Administrator's Manual

Screen Reference

Signaling Group

Translation-ID Number Mismatch Interval
(days)
A display-only field for all logins except init; only init logins can change this field. This field specifies
the interval (in days) that the system allows a mismatch between the translation ID stored in the Processor
circuit pack(s) and on the flash card. Following expiration of this interval, the ability to execute system
administration commands that modify translation data is denied for all logins, except for init.
Valid entries
1-90
Signaling Group
Use this screen to establish signaling group parameters for ISDN-PRI, H.323, ATM, and SIP trunks.
Because these trunk types vary in the types of parameters needed, the fields that appear on this screen
change depending on the value of the
reference.
Field descriptions for page 1
Figure 331: Signaling Group when the Group Type field is atm
Group Number
Trunk Group for Channel Selection:
CIRCUIT PARAMETERS
Virtual Path Identifier: 0
Virtual Channel Identifier: 0
1140
Usage
Enter a number to indicate the number of days the system allows
access to system administration commands.
Group Type
___ Group Type:
D-Channel:
Supplementary Service Protocol: _
Signaling Mode: isdn-pri
Idle Code: 11111111
Interface Companding: mulaw
Country Protocol: 1
Protocol Version: d
Administrator's Guide for Avaya Communication Manager
field. Field descriptions are alphabetized for easier
SIGNALING GROUP
atm___
Max Number of NCA TSC: ___
Max number of CA TSC:
Trunk Group for NCA TSC:
___
Network Call Transfer? n
Circuit Type: T1
DCP/Analog Bearer Capability: 3.1kHz
Interworking Message: PROGress
Page 1 of 5
Name:
___
___
Connect: network
November 2003