Avaya Communication Manager Administrator's Manual page 1310

Screen Reference
Trunk Group
Seize Ack Send (msec)
This field appears only if the
two-way. Only TN2140 ports receive this timer.
Valid entries
10 to 990 in
increments of
10
Send Incoming/Outgoing Disconnect Timers
to TN465 Ports
The field appears only for a co, fx, or wats trunk group.
Valid entries
y/n
END TO END SIGNALING
Pause (msec)
THis field is administrable only if the
accept administrable timers accept this timer. However, this timer is sent only to the following circuit
packs: TN464B (or later), TN767, TN436B, TN459B, TN2146, TN2199, and TN2242, and TN429 and
TN2184 ports in a DID trunk group.
Valid entries
20 to 2550 in
increments of
10
Tone (msec)
This field appears only if the
administrable timers accept this timer. This timer is also sent to the following circuit packs: TN464B (or
later), TN767, TN436B, TN459B, TN2146, TN2199, TN429, TN2184 ports in a DID trunk group.
Valid entries
20 to 2550 in
increments of
10
1310
field is dis and the trunk group Direction field is incoming or
Trunk Type
Usage
Enter the duration of the seizure acknowledgment signal your server
running Communication Manager sends in response to an incoming
seizure.
Usage
Enter y if you want to send the incoming disconnect and outgoing
disconnect timer values to the trunk group ports that are on a TN465
board.
Trunk Type
Usage
Enter the minimum acceptable interval (pause) between DTMF
tones sent from a hybrid phone.
field is blank. All CO, DIOD, and Tie circuit packs that accept
Trunk Type
Usage
Enter the duration of a DTMF tone sent when a button on a hybrid
phone is pressed.
Administrator's Guide for Avaya Communication Manager
field is blank. All CO, DIOD, and tie circuit packs that
November 2003