Avaya Communication Manager Administrator's Manual page 1286

Screen Reference
Trunk Group
Valid entries
tge
(for incoming
trunks)
tgi
(for internal
trunks)
DIOD trunks support pulsed and continuous E&M signaling in Brazil and discontinuous
E&M signaling in Hungary. Use the following entries for DIOD trunks. Use these values
only when all trunk group members are assigned to a TN464F (or later version) or TN2464
circuit pack.
cont
pulsed
discont
Trunk Termination
This field adjusts the impedance of the trunk group for optimal transmission quality. Check with your
service provider if you're not sure of the distance to your central office.
Valid entries
600ohm
rc
1286
Usage
Enter tge at a satellite server to administer a tie trunk group
connected to the main server running Communication Manager.
(This same group should be administered as tgu at the main server.)
Enter tgi at to administer a two-way tie trunk group between 2
satellites or between the main server and a satellite. (This trunk group
should be administered as tgi on both servers.)
Enter cont for continuous E&M signaling.
Enter pulsed for pulsed E&M signaling.
Leave blank forR2 signaling.
Hungary uses discontinuous E&M signaling when this field is dis.
Brazil E&M trunks use continuous and pulsed E&M.
Usage
Enter 600ohm when the distance to the central office or the media
server or switch at the other end of the trunk is less than 3,000 feet.
Enter rc when the distance to the central office or the media server
or switch at the other end of the trunk is more than 3,000 feet.
Administrator's Guide for Avaya Communication Manager
November 2003