Avaya Communication Manager Administrator's Manual page 981

Modify Tandem Calling Number
This field appears when
Send Calling Number
on the ISDN -Tandem Calling Party Number screen..
Valid entries
y/n
NCA-TSC Trunk Member
Identifies the trunk member whose D-channel will be used to route tandem NCA-TSCs or QSIG CISCs.
Value range for this field is from 1 to the maximum number of members per trunk group supported on the
server/switch, or blank.
Network (Japan) Needs Connect Before
Disconnect
Sends an ISDN Connect message just prior to the Disconnect message.
Numbering Format
This field appears if the
or r. This specifies the encoding of Numbering Plan Indicator for identification purposes in the Calling
Number and/or Connected Number IEs, and in the QSIG Party Number. Valid entries are public,
unknown, private, and unk-pvt. Public indicates that the number plan according to CCITT
Recommendation E.164 is used and that the Type of Number is national. Unknown indicates the
Numbering Plan Indicator is unknown and that the Type of Number is unknown. Private indicates the
Numbering Plan Indicator is PNP and the Type of Number is determined from the ISDN
Private-Numbering screen. An entry of unk-pvt also determines the
Private-Numbering screen, but the
Outgoing Channel ID Encoding
Appears only if the
sddn. Determines whether to encode the Channel ID IE as preferred or exclusive. Blank is not a valid
entry. Defaults are determined as follows:
If the
Group Type
If the
Group Type
If the Group Type
preferred.
Administrator's Guide for Avaya Communication Manager
November 2003
is ISDN, Direction is either Outgoing or Two-way, and
Trunk Group Type
is either y or r. It is used to control whether call processing processes the entries
Usage
Enter y to modify the calling party number IE in the format
specified on the ISDN-Tandem Calling Party Number screen.
Default is n.
Send Calling Number
Numbering Plan Indicator
field is isdn and the
Group Type
field is isdn and the
Used for DCS
field is isdn and the
Used for DCS
field is not isdn or it is isdn, but the
field is y or r or the
Send Connected Number
Type of Number
is unknown.
field is anything except dmi-mos or
Service Type
field is y, default is exclusive.
field is n, default is preferred.
Used for DCS field does not appear, default is
Screen Reference
ISDN Trunk Group
field is y
from the ISDN
981