Busy Tone Disconnect - Avaya Communication Manager Administrator's Manual

Screen Reference
Trunk Group
Figure 374: Administrable Timers for Trunk Group
add trunk-group next
Incoming Glare Guard(msec): _____
Ringing Monitor(msec): _____
Outgoing End of Dial(sec): ___
Programmed Dial Pause(msec): _____
END TO END SIGNALING
Tone (msec): ____
OUTPULSING INFORMATION
PPS: 10
CAUTION:
Customers: Do not change fields on this page without assistance from Avaya or your
network service provider.
Answer Send (msec)
This field appears only if the
two-way. Only TN2140 and TN2199 ports receive this timer.
Valid entries
10 to 2550 in
increments of 10

Busy Tone Disconnect

The field appears when
Parameters Country-Options screen.
Valid entries
y/n
1302
ADMINISTRABLE TIMERS
Send Incoming/Outgoing Disconnect Timers to TN465 Ports? _
Flash Length(msec): ____
Pause (msec): 150
Make(msec): 40
field is dis and the trunk group
Trunk Type
Usage
Enter the duration of the answer signal pulse.
Enable Busy Tone Disconnect for Analog loop-start Trunks
Usage
Enter y to allow Communication Manager to recognize a busy tone
signal as a disconnect on this trunk group.
Administrator's Guide for Avaya Communication Manager
Outgoing Dial Guard(msec): _____
Outgoing Glare Guard(msec): _____
Outgoing Rotary Dial Interdigit (msec): ____
Incoming Seizure(msec): ____
Outgoing Seizure Response(sec): ___
Disconnect Signal Error(sec): ___
Busy Tone Disconnect?
Break(msec): 60 PPM? y
Page 3 of x
Frequency: 50/12k
field is incoming or
Direction
is y on the System
November 2003