Avaya Communication Manager Administrator's Manual page 1309

Programmed Dial Pause (msec)
This timer is administrable for all outgoing and two-way trunk groups. This timer works with the
TN464B (or later), TN767, TN458, TN2140, and TN2242 tie circuit packs. All CO circuit packs that
accept administrable timers accept this timer.
Valid entries
100 to 25500 in
increments of
100
Release Ack Send (msec)
After your server running Communication Manager receives a forward release signal, it must send a
forward release acknowledgment signal. This field appears only if the
trunk group
Direction
Valid entries
500 to 1200 in
increments of
100
Ringing Monitor (msec)
This timer is sent to TN464C (or later), TN767, TN438 (all), TN447, TN465 (all), TN2138, TN2147,
TN2184, and TN2199 CO circuit packs.
Valid entries
200 to 51000 in
increments of
200
Seize Ack Delay (msec)
This field appears only if the Trunk Type field is dis and the trunk group Direction field is incoming or
two-way. Only TN2140 ports receive this timer.
Valid entries
40 to 120 in
increments of
10
Administrator's Guide for Avaya Communication Manager
November 2003
Usage
Set the exact duration of pauses used during abbreviated dialing,
ARS outpulsing, and terminal dialing operations.
field is incoming or two-way. Only TN2140 ports receive this timer.
Usage
Enter the duration of the signal your server running Communication
Manager sends for a forward release acknowledgment.
Usage
Enter the minimum time Communication Manager requires to
determine if a trunk disconnects. The field cannot be blank. If the
ringing signal disappears for a duration longer than the time
specified in this field, Communication Manager assumes the call
has been disconnected.
Usage
Enter the maximum interval your server running Communication
Manager will wait after receipt of an incoming seizure to send
seizure acknowledgment.
Screen Reference
Trunk Group
field is dis and the
Trunk Type
1309