Avaya Communication Manager Administrator's Manual page 1305

Incoming Glare Guard (msec)
This field only appears when the trunk group Direction field is two-way.
Valid entries
100 to 25500 in
increments of
100
Incoming Incomplete Dial Alarm (sec)
Only the TN436 (all), TN459 (all), TN464C (or later), TN767, TN2140, TN2146, TN2184, TN2199, and
TN2242 circuit packs use this timer.
Valid entries
1 to 255 in
increments of 1
Incoming Partial Dial (sec)
This timer appears only if the Incoming Dial Type field is rotary.
Valid entries
5 to 255 in
increments of 1
NOTE:
This timer is never sent to TN429 ports.
Incoming Seizure (msec)
This field appears when the
field is cont. Only TN429, TN438 (any release), TN 447, TN464C (or later), TN465 (any release),
Type
TN767, TN2138, TN2140, TN2147, TN2184, and TN2199 ports receive this timer. For DID trunks, only
TN2199 and TN429D (or later) receive this timer.
Valid entries
20 to 2550 in
increments of
10
Administrator's Guide for Avaya Communication Manager
November 2003
Usage
Enter the minimum interval that must elapse between a trunk's
release from an incoming call and its seizure for an outgoing call.
This field cannot be blank. This delay gives the far-end time to
release all equipment after the trunk is released.
Usage
Enter the maximum acceptable interval between an incoming
seizure and receipt of all digits. Intervals greater than this limit
generate an inline error.
Usage
Enter the maximum time allowed between incoming rotary digits.
field is incoming or two-way, and, when applicable, the
Direction
Usage
Enter the duration of the shortest incoming seizure signal your
server running Communication Manager can recognize. For ICLID,
set this field to 120. The field cannot be blank.
Screen Reference
Trunk Group
Trunk
1305