Avaya Communication Manager Administrator's Manual page 946

Screen Reference
IP Network Region
codec-set
Indicates which codec set is to be used between the two regions. .
Valid
entries
1-7
direct-WAN
The entry in this field indicates whether the two regions (source and destination) are directly connected
by a WAN link. .
Valid
entries
y/n
WAN-BW limits (value)
This field is used for entry of the bandwidth limits for direct WAN links.
Valid
entries
1-9999
WAN-BW limits (units)
The entry in this field the unit of measure corrsesponding to the value entered for bandwidth limitation.
Valid entries
Calls,
Kbits/sec,
Mbits/sec,
NoLimit
946
Usage
If the two regions are not connected at all, this field should be blank.
When the codec set is blank, the
entry fields are not displayed. This field cannot
Intervening-regions
be blank if this route through two regions is being used by some
non-adjacent pair of regions.
Usage
The default value is y(es) if the
the WAN-BW-limits field displays, but the
fields do not. If the direct-WAN
field does not display, but the
WAN-BW-limits
fields are displayed.
Usage
Values for this field may be entered in the number of connections,
bandwidth in Kbits/sec, bandwidth in Mbits/sec, or left blank.
Default is blank.
Note: For Release 2.0, The number must be less than or equal to 65
when the units part of the field is set to Mbits/sec.
Usage
This field allows you to limit bandwidth by number of connections,
bandwidth in Kbits/sec, bandwidth in Mbits/sec, or it can be left
blank. Default is blank.
Administrator's Guide for Avaya Communication Manager
direct-WAN , WAN-BW-limits
codec-set field is not blank. If so,
Intervening-regions
field is set to n(o), then the
Intervening-regions
, and
November 2003