Avaya Communication Manager Administrator's Manual page 1301

Start Position
The value administered in this field must be coordinated with your central office. This field appears when
the Country field is 15 and the
Valid entries
1 to 9
Suppress # Outpulsing
Valid entries
y/n
Time (sec) to Drop Call on No Answer
This field appears if the
Group Type fUsed for DCS
Valid entries
y/n
NOTE:
This field cannot be activated if the trunk group number is greater than 255 or if the Trunk
Access code is more than 3-digits long.
If this field is y, you can administer ISDN-BRI trunk groups unless the
field is d-chan. In that case, remove the BRI trunks or set the
bx.25 before submitting the screen.
Field descriptions for page 3 - Group Type co
The figure below shows a common configuration for page 3 of the Trunk Group screen when the
field is co. This screen is only an example, and the fields shown below may change or disappear
Type
according to specific field settings. The field descriptions that follow may include fields from other group
types that are not shown on this example screen.
Administrator's Guide for Avaya Communication Manager
November 2003
Shuttle field is y.
Usage
Indicate which digit in the digit string is considered to be the
"previously sent" digit (see
Usage
Enter y if end-to-end signaling begins with (and includes) "#". The
final "#" is suppressed in cases where the system would normally
outpulse it. This field should be y when the Central Office (for
example, rotary) or any other facility treats "#" as an error.
Group Type field is co or diod and the
Usage
Enter y if this trunk group will send and receive messages on a DCS
signaling link.
Start B Signal on page 1300).
Outgoing Dial Type
Screen Reference
Trunk Group
field is mf, or if the
DCS Signaling
DCS Signaling field to
Group
1301