Avaya Communication Manager Administrator's Manual page 1311

OUTPULSING INFORMATION
Break (msec)
Valid entries
Enter the duration of the break interval (the pulse duration) while the system is
outpulsing digits using dial pulse signaling. The field cannot be blank.
20 to 80 in
increments of 5
10 to 40 in
increments of 5.
Frequency
This field identifies the PPM pulse frequency(ies) sent by the public network. It appears if the Direction
field is outgoing or two-way and PPM is y. Circuit packs can detect up to three different frequencies,
(12kHz, 16kHz, and 50Hz), plus two frequency combinations, (50Hz/12kHz and 50Hz/16kHz). This
field controls TN465B, TN2138, and TN2184 circuit packs.
Valid entries
12k
16k
50
50/12k
50/16k
Administrator's Guide for Avaya Communication Manager
November 2003
Usage
If PPS field is 10, the sum of the Make (msec) and Break (msec)
fields must equal 100.
If the PPS field is 20, the sum of the Make (msec) and Break (msec)
fields must equal 50.
Usage
The TN465B (or later) and TN2184 can only detect 12k and 16kHz
PPM. Therefore, if 12k is administered, the circuit pack will be set
to detect 12kHz.
The TN465B (or later) and TN2184 can only detect 12k and 16kHz
PPM. Therefore, if 16k is administered, the circuit pack will be set
to detect 16kHz.
The TN465B (or later) and TN2184 can only detect 12k and 16kHz
PPM. Therefore, if 50 is administered, the circuit pack will be set to
detect 16kHz.
The TN465B (or later) and TN2184 can only detect 12k and 16kHz
PPM. Therefore, if 50/12k is administered, the circuit pack will be
set to detect 12kHz.
The TN465B (or later) and TN2184 can only detect 12k and 16kHz
PPM. Therefore, if 50/16k is administered, the circuit pack will be
set to detect 16kHz.
Screen Reference
Trunk Group
1311