Avaya Communication Manager Administrator's Manual page 1079

Forward Cycle Timer (sec)
Appears when the
Valid entries
1 to 255
Group II Called Party Category
Appears when the
Responses field is n. Enter the type of group II signals that should be used on the outgoing R2-MFC
call.
NOTE:
For India, the ANI can be requested without the Incoming Call Type information.
Valid entries
user-type
call-type
This field defines the signal type that a CO uses to place an incoming call to the PBX.
Valid entries
group-ii-mfc
non-group-ii-mfc
mfe
Administrator's Guide for Avaya Communication Manager
November 2003
field is mfe.
Incoming Call Type
Usage
Enter the number of seconds to wait to receive the check frequency
after sending an MFE signal. Communication Manager drops the call
if the time runs out before it receives check frequency.
Outgoing Call Type field is group-ii-mfc and the
Usage
The type of phone making the call determines the type of group II
signal that the PBX sends (normal = ordinary phone set, attendant =
attendant console, data-call = data modules and similar data
endpoints).
The dialed digits determine the type of group II signal that the PBX
sends.
Usage
If the value of this field is group-ii-mfc, the second page of the
screen will display entries for all group-I, group-II, group-A, and
group-B signal types with a set of default values (see page 2 of
screen).
If the value is non-group-ii-mfc, the second page displays only
group-I and group-A signal types.
Use only in Spain (multi-frequency Espanol)
Screen Reference
Multifrequency-Signaling-Related Parameters
Use COR for All Group II
1079