Avaya Communication Manager Administrator's Manual page 1307

Outgoing End of Dial (sec)
This field controls firmware answer supervision timers on circuit packs that have them. It appears when
the Direction field is outgoing or two-way and the
Receive Answer Supervision field is y, this field does not appear and the firmware timer on the
appropriate circuit pack is automatically disabled.
NOTE:
The
answer supervision for circuit packs without administrable timers. Since trunk groups may
contain ports on more than one circuit pack, it's possible you may need to use both timers
with the same trunk group. If so, set the
Supervision Timeout field to the same value.
Valid entries
1 to 254 in
increments of 1
During a cut-through operation, timing begins after Communication Manager sends each outgoing digit
and ceases when answer supervision is received. If the timer expires, Communication Manager acts as if
it has received answer supervision. On senderized operation, the timer begins after the switch sends the
last digit collected. The timer ceases when answer supervision is received. If the timer expires,
Communication Manager acts as if it has received answer supervision.
Outgoing Glare Guard (msec)
This field only appears for outgoing and two-way trunk groups.
Valid entries
100 to 25500 in
increments of
100
Outgoing Last Digit (sec)
This field is only administrable if the
is two-way or outgoing. Only TN497 and TN2140 ports receive this timer.
Valid entries
1 to 40 in
increments of 1
Administrator's Guide for Avaya Communication Manager
November 2003
Answer Supervision Timeout
Usage
Enter the maximum time, in seconds, that Communication Manager
will wait to receive answer supervision for outgoing calls on the
ports controlled by firmware timers. For Brazil pulsed E&M
signaling, use 40.
Usage
Enter the minimum interval that must elapse between a trunk's
release from an outgoing call and its seizure for another outgoing
call. This field cannot be blank. This delay gives the far-end time to
release all equipment after the outgoing trunk is released.
Trunk Type
Usage
Enter the maximum time that Communication Manager will wait for
the next digit dialed. After the timer expires, no more digits are
accepted by the circuit pack.
Receive Answer Supervision
field on the Trunk Group screen provides timed
Outgoing End of Dial
field is dis or cont and the trunk group
Screen Reference
Trunk Group
field is n. If the
field and the Answer
Direction field
1307