Avaya Communication Manager Administrator's Manual page 1183

Port
Enter 7 characters to specify a port, or an x. If this extension is registered as an IP endpoint, this field will
display s XXXXXX
there are 312 IP sets already registered when you register, your extension would get port s000313.
Valid entries
01 through 44
(DEFINITY R)
01 through 03
(DEFINITY SI)
A through E
01 through 20
01 through 32
x
IP
For DCP sets, the port can only be assigned once. ISDN-BRI provides a multipoint configuration
capability that allows a previously assigned port to be specified more than once as follows: 2
stand-alone voice endpoints, 2 stand-alone data endpoints, or 1 integrated voice and data
endpoint.
However, for the following cases, the port is assumed to be fully assigned:
— Maximum number of users (currently 2) are assigned on the port.
— One of the users on the port is a fixed TEI station.
— One of the users on the port has B-channel voice and B-channel data capability.
— One of the users on the port has no SPID assigned, which includes telephones that have no
SPID initialization capability.
— This field is display-only for H.323 set types and 4600 set types. The system assigns an
"IP" when the station is first administered.
Administrator's Guide for Avaya Communication Manager
November 2003
, where XXXXXX is the number of previously registered IP stations. For example, if
Usage
First and second numbers are the cabinet number
Third character is the carrier
Fourth and fifth characters are the slot number
Sixth and seventh characters are the circuit number
Indicates that there is no hardware associated with the port
assignment since the switch was set up, and the administrator
expects that the extension would have a non-IP set. Or, the
extension had a non-IP set, and it dissociated. Use x for
AWOH and CTI stations, as well as for SBS Extensions.
Indicates that there is no hardware associated with the port
assignment since the switch was set up, and the administrator
expects that the extension would have an IP set. This is
automatically entered for certain IP station set types, but can
be entered for a DCP set with softphone permissions. This
changes to the s00000 type when the set registers.
Screen Reference
Station
1183