Avaya Communication Manager Administrator's Manual page 860

Screen Reference
Feature-Related System Parameters
On-hook Dialing on 607/2420/4600/6400/8400
Terminals
For 6400/8400, 607, 2420, and 4600 telephone users with speakerphones.
Valid entries
y/n
The next four fields control station-to-switch recall signal timing. If a flashhook interval (recall window)
is required, the upper and lower bounds of the interval can be administered. An on-hook that lasts for a
period of time greater than or equal to the lower bound and less than or equal to the upper bound will be
treated as a recall flash. If an interval is not required, the Disconnect Timing value must be administered.
An on-hook that lasts for a period of time less than this value will be ignored; greater than or equal to this
value will be regarded as a disconnect. Regardless, an on-hook lasting 50 to 150 ms coming from a
2500-type set will always be treated as a digit pulse unless Ignore Rotary Digits is y for that station.
Outpulse Without Tone
Valid entries
y
n
Pull Transfer
Valid entries
y/n
Repetitive Call Waiting Interval (sec)
This field appears when the
Valid entries
1 to 99
860
Usage
Enter y allows users to dial without lifting the handset. If you enable
this, users hear dial tone when they press the Speaker button, even if
the handset is on-hook.
Usage
Enter y to indicate the server will outpulse digits even when a dial
tone has not been received.
Enter "n" if the calling party should receive intercept tone if no dial
tone is detected.
Usage
Enter y to enable the Pull Transfer feature on a system-wide basis.
This allows either the transferring or transferred-to party to press
the Transfer button to complete the transfer operation
Repetitive Call Waiting Tone
Usage
Enter a number to specify the number of seconds between call
waiting tones.
Administrator's Guide for Avaya Communication Manager
field is y.
November 2003