Avaya Communication Manager Administrator's Manual page 1614

Feature Reference
Multifrequency signaling
•
Call Detail Recording (CDR)
CDR records ANI collected from incoming MF signaling.
For India MFC, on incoming calls, ANI digits may be appended with zeroes if the actual ANI
digits are less than the administered ANI-length; in those cases, the zero-digits appear on CDR.
•
Call Redirection
A call is redirected if any of the following are active: Call Forwarding, Call Coverage, Send All
Calls, or Night Service.
•
Call Vectoring
Call Vectoring can now use ANI collected from incoming MFC signaling.
The ANI of a call vector is not used when a call vectoring route-to command routes a call over an
outgoing trunk. Instead, the ANI of the originating party is sent.
•
DID No Answer Timer
DID No Answer Timer is applied to MF signaling DID calls.
•
Distributed Communications System (DCS)
In a DCS arrangement, the ANI sent to the CO is determined by the ANI for PBX on PBX_B, but
the category sent to the CO is determined by the Category for MF ANI field on the Class of
Restriction screen for the incoming DCS trunk or by the type of call.
•
Expert Agent Select (EAS)
For ANI, the EAS agent's login extension number and COR overrides the extension number and
COR of the physical terminal where the agent is logged in. ANI prefix and ANI truncation apply
to logged in EAS agents.
•
Hunt Groups and Automatic Call Distribution (ACD) Splits
For ANI, a physical terminal's extension number and COR overrides the extension number and
COR of the hunt group or ACD split that the terminal is a member of or logged into. ANI prefix
and ANI truncation apply to terminals that are members of hunt groups or logged into ACD splits.
•
Intercept treatment
For DID MF signaling calls that are denied, you can administer whether the corresponding B.x
signal or intercept tone should be sent to the CO. The default is to send the administered
DID/TIE/ISDN Intercept Treatment. If the option to send the B.x signal is set, then:
— For Group II calls, the B.x signal for the intercept is sent to the CO.
— For non-Group II calls, if the CO dials an invalid number, the trunk is locked (regardless
of this option). If the CO dials a number that is valid but not assigned, intercept tone is
sent to the CO.
•
Multimedia Call Handling (MMCH)
For call origination, multimedia complexes use the COR assigned to their telephones. ANI prefix
and ANI truncation will apply to the telephones assigned to multimedia complexes.
•
Off-Net Call Coverage or Call Forwarding
If the originating endpoint is an extension, the extension's ANI is used. If the originating endpoint
is an incoming trunk that can supply ANI, the ANI received from the incoming trunk is used. If
the originating endpoint is neither of the above, the ANI for PBX is used.
1614 Administrator's Guide for Avaya Communication Manager
November 2003