Policy Condition Destination Port Group - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

QoS Policy Commands

policy condition destination port group

Associates a destination port group with a policy condition. Note that this condition is supported only in
combination with a multicast condition (multicast ip, multicast ipv6, or multicast network group).
policy condition condition_name destination port group group_name
policy condition condition_name no destination port
Syntax Definitions
condition_name
group_name
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the no form of the command to remove a destination port group from a condition; however, at least
one classification parameter must be associated with a condition.
Examples
-> policy condition cond6 destination port group portgr4 multicast ip any
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply
policy port group
policy condition
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition. May be an existing condition name or a new
condition.
The name of the destination port group. Port groups are configured
through the policy port group
Applies configured QoS and policy settings to the current configuration.
Configures a port group and its associated slot and port numbers.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
November 2009
command.
page 39-107