Policy Condition Ip Protocol - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

QoS Policy Commands

policy condition ip protocol

Configures an IP protocol for a policy condition.
policy condition condition_name ip protocol protocol
policy condition condition_name no ip protocol
Syntax Definitions
condition_name
protocol
Defaults
parameter
protocol
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of the command to remove a protocol from a condition; however, at least one classifi-
cation parameter must be associated with a condition.
•
If a source or destination port is specified (through the policy condition source ip port or policy
condition destination ip port commands), the protocol must be specified.
•
The same condition cannot specify an IP protocol with a service or service group.
Examples
-> policy condition cond4 ip protocol 6
Release History
Release 6.6.1; command was introduced.
Related Commands
policy condition source ip port
policy condition destination ip
port
qos apply
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition.
The protocol associated with the flow. The range is 0–255.
default
6
Configures a source IP port number for a policy condition.
Configures a destination IP port number for a policy condition.
Applies configured QoS and policy settings to the current configuration.
Shows information about policy conditions configured on the switch.
November 2009 page 39-79