Ip Slb Server Ip Cluster - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ip slb server ip cluster

ip slb server ip cluster
Adds a physical server to a Server Load Balancing (SLB) cluster, deletes a physical server from an SLB
cluster, or modifies the administrative status of a physical server in an SLB cluster.
ip slb server ip ip_address cluster cluster_name [admin-state {enable | disable}] [weight weight]
no ip slb server ip ip_address cluster cluster_name
Syntax Definitions
ip_address
cluster_name
enable
disable
weight
Defaults
parameter
enable | disable
weight
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove a physical server from a Server Load Balancing cluster.
•
Use the weight parameter to assign the server preference value. Each server or server cluster can be
assigned a weight to set their preference value for distribution of incoming network traffic. The weights
assigned are relative. For example, if Servers A and B have respective weights of 10 and 20 within a
cluster, Server A would get half the traffic of Server B.
•
Assigning a weight of 0 (zero) to a server prevents the server from being assigned any new
connections. This server is a backup server.
•
A higher weight value indicates that the server can accept more network traffic.
Examples
-> ip slb server ip 10.255.11.127 cluster corporate_servers
-> ip slb server ip 10.255.11.109 cluster "mail servers" admin-state enable
weight 5
-> no ip slb server ip 10.255.11.105 cluster hr_servers
page 20-14
The IP address for the physical server.
The name of an existing Server Load Balancing cluster.
Enables a server.
Disables a server.
Specifies the weight of the server.
default
enable
1
Server Load Balancing Commands
OmniSwitch CLI Reference Guide March 2011