Table of Contents
Advertisement
Kind of input connector:
•
if the protection cap is green the optical input interface is a angled physical
connector (APC-type)
•
if it is a black protection cap, the interface type is physical connector (PC-type)
OSCA optical spectrum analyzer Setup
To configure the 8000 V2 Platform in preparation for an OSCA test on a fiber, press the
S
button.
ETUP
The various measurement parameters are proposed:
1
Setup in Test Auto mode
Acquisition settings
Sweep range
Averaging acquisition
Resolution
Analyze settings
Channel detection
Signal threshold
Min channel spacing
OSNR method
S<->N distance
Noise acq BW
SNR Meas. Type
Splitter compensation
Tilt & Slope Gain
Results screen settings
Wavelength range
Table Content
Mode
Sweep
Grid
Alarms
User Manual
Chapter 9 OSCA-710 Optical Spectrum Measurement
OSCA optical spectrum analyzer Setup
WDM / OSNR
single, continuous
Full, Start/End, Center, Span
Permanent, Grid
OSNR
Auto
default = last value used
78000010220 Rev. 024
POL-MUX
No
0.3 pm
Auto
Std 50GHz
left & right
Not available
std 0.1 nm
S/N
No
No
No
Auto
Standard
309
Advertisement
Table of Contents
Troubleshooting
