Viavi 8100 V2 Series User Manual page 171

Figure 73 Acquisition in progress
At the end of the acquisition, a beep is emitted, the trace is displayed and an
automatic measurement is started.
NOTE
During acquisition, the traffic on fiber is automatically detected (see
Detection" on page
If the module possesses several lasers, to perform successive acquisitions on all the
wavelengths:
1 In the S
select
2 Start the acquisition by pressing the S
3 Once the acquisition for the first wavelength is finished, the acquisition for the
following wavelength starts automatically.
or
To stop manually the acquisition for current wavelength, click on
length. This will allow to automatically start the measurement for the following
wavelength.
A beep is emitted once the acquisitions on all lasers are completed.
Number of
Elapsed
acquisition averages
time calculated
56).
menu, check in Laser line, that
ETUP
All.
User Manual
Chapter 3 Reflectometry measurements
Total
Elapsed
acquisition
time
time
several lasers are selected or
/S button.
TART TOP
78000010220 Rev. 024
FTTA-SLM option
"Traffic
Stop Wave-
135