Activate The Cd Or Ap Function On T-Berd/Mts 8000 V2; Activate The Bbs Source On T-Berd/Mts 6000 - Viavi 8100 V2 Series User Manual

Chapter 17 Fiber Characterization
Referencing the test functions
1 Connect a fiber jumper to the MTAU COM port of T-BERD/MTS 8000 V2 and to
the test module of the T-BERD/MTS 6000A V2.
2 Connect both jumpers together using the appropriate mating adapter.
See below the interconnection schematic.
Figure 233 Interconnection for CD/AP Referencing in Bidirectionnal mode
3 Press O
Activate the CD or AP function on T-BERD/MTS 8000
V2
Once the T-BERD/MTS 8000 V2 is switched on:
1 On the Home page, select CD icon
2 Wait for the self calibration process of the DISPAP module (~1min.).
3 Press the hard key R
4 Press the soft key

Activate the BBS Source on T-BERD/MTS 6000

Once the T-BERD/MTS 6000 is switched on:
466
/O to turn both units on and wait the completion of auto-test (45 sec.)
N FF
ESULTS
until OUT B is selected
User Manual
or AP icon
and touch the MTAU tab.
78000010220 Rev. 024
.