Quitting The Overlay Menu; Table Of Results - Viavi 8100 V2 Series User Manual

Removing all the traces
To remove all the traces except the current trace, press the key

Quitting the overlay menu

To quit the overlay menu, press the

Table of results

Lines
According to the choice made in the S
• either a line for each channel detected (if Channel Selection = Permanent)
• or a line for each graduation, (if Channel Selection = Grid and a grid is selected)
Type of display
The table may be displayed in a single line, on half of the screen or the whole screen as
a function of the Trace/Table key (see
Contents of the table without statistics
In the absence of statistics (see
given for each channel are:
1 the number of the channel
2 the frequency or the channel wavelength according to the unit selected
3 the spacing between the channels in THz or in nm
4 the level of the channel in dBm
This parameter indicates the calculated total channel power level from the
detected channels, achieved by mathematical power integration over ± ½ min
channel spacing around the channel center frequency.(see
spacing 1" on page
indicated by cursor evaluation in the graphical trace.
5 The noise level in dBm
Exit
"Analysis parameters" on page
386). This power level may differ from the peak power level
User Manual
Chapter 12 High Resolution OSA Measurement
key.
menu, the table of results may include:
ETUP
"Trace /Table key" on page
78000010220 Rev. 024
Table of results
Remove Other Traces.
393)
386) the parameters
"Min. Channel
399